Search

TS29 Shaper, 7.5HP 3PH 230/460V

1791284

The new TS29 Tilt/Slide Shaper is ready to tackle any job. A new fence design includes dual digital readouts, micrometer adjustments and independently adjustable fence halves for fast, accurate set-ups. The full guard includes two stock hold-downs and a see-through cover that flips up for quick tool changes. Dual dust collection ports, in the guard and under the table insure a clear work area and improved finish. An extra large quill assembly with a full seven inch stroke has three oversize bearings and the ability to tilt, adding versatility and insuring long, trouble-free performance. Powered by a big 7-1/2HP motor that drives the spindle forward and reverse with five speeds. The massive sliding table is fully supported by six tapered precision bearings through a full four-foot stroke. In addition, on board the table is a large miter head complete with stock hold-down clamp and a 56" miter fence with flip stop. The large table can easily accommodate a stock feeder for longer production runs.

Features

Sliding table with 4-foot stroke works with miter head, hold-down and fence to accommodate everything from multiple end cuts to tenons
Fully adjustable fence with dual digital readout for fast, accurate set-up and repeatability
Large table with built-in slider with room for stock feeder
7" vertical spindle travel allows stacked tooling
Spindle tilts negative 5° to positive 45° for increased versatility
Large diameter multiple table inserts accommodate virtually any size cutter
Five spindle speeds in forward and reverse with lighted indicator

Specifications

Style (Type)
Shaper
Spindle Speed (RPM)
3,000, 4,000, 6,000, 8,000, 10,000
Maximum Spindle Diameter (In.)
1-1/4
Spindles Included
3/4, 1, 1-1/4
Spindle Size Under Nut (In.)
3/4 (3-1/2), 1 (6), 1-1/4 (6-1/2)
Spindle Travel (In.)
7
Spindle Tilt (Deg.)
45 Forward, 5 Back
Reversible
Yes
Router Bit Collet Included
1/4, 1/2
Maximum Diameter Cutter Above Table (In.)
12
Maximum Diameter Cutter Below Table (In.)
9
Table Inserts (In.)
2-1/5, 5-1/2, Oval (Tilting)
Table Size (In.)
51-1/2 x 33-1/2
Table Travel (In.)
49-1/4
Sliding Table Size (In.)
11-1/4 x 51-1/4
Fence Size (L x H) (In.)
46 x 5
Fence Travel (Major and Minor) (In.)
5-3/8, 3-5/8
Dust Port Outside Diameter (In.)
5 (x2)
Dust Collection Minimum CFM Required (CFM)
800
Electrical Controls
24 volt
Motor Power (HP)
7-1/2
Motor Phase
3
Motor Voltage (V.)
230/460
Prewired Voltage (V.)
230
Recommended Circuit Size (Amps.)
30/15